Dixon® RDM11 Hose Mender, 1 in, Hose Shank, 316 Stainless Steel

DIXRDM111316SS MFG #: RDM11

Dixon® Hose Mender, Fitting/Connector Type: Mender, 1 in Nominal Size, Hose Shank, 4-1/32 in Length, 316 Stainless Steel, 1-1/32 in Dia

Mender for connecting two hoses of the same diameter in a straight run
Hose barbs on both ends
316 stainless steel for higher strength and greater corrosion resistance than 304 stainless steel
Barbed fitting for a tight seal on hoses
For use with a hose clamps or crimp sleeve or ferrule
Menders are not for compressible products such as air, nitrogen or steam
The working pressure may vary with the construction of the hose, the type of clamping system used and the application
In accordance with the R.M.A. bulletin for oil suction and discharge hose, a coupled length of hose in any size, should be tested to 1-1/2 times the working pressure and held for fifteen minutes without leaking or coupling movement
Warning: this product contains a chemical known to the state of California to cause birth defects or other reproductive harm
Do not use in connection with drinking water
Wash hands after handling

▲