Zoeller®

Zoeller® 57-0001 M57 Mighty-Mate Effluent or Dewatering Submersible Pump, Automatic, 1/3 hp, 115V, Cast Iron

ZOEM57 MFG #: 57-0001
Zoeller® 57-0001 M57 Mighty-Mate Effluent or Dewatering Submersible Pump, Automatic, 1/3 hp, 115V, Cast Iron
  • Flow Rate: 43 gpm
  • Motor HP: 3/10 hp
  • Series: Mighty-Mate
  • Voltage Rating: 115 V
  • Amperage Rating: 9.7 A
  • Bearing Type: Sleeve
  • Cord Length: 9 ft
  • Cord Type: 3-Wire
  • Frequency Rating: 60 Hz
  • Impeller Type: Non-Clogging Vortex
  • Manufacturer: Zoeller Company
  • Manufacturer #: 57-0001
  • Material: Cast Iron
  • Maximum Head: 19-1/4 ft
  • Non-Automatic / Automatic: Automatic
  • Outlet Size: 1-1/2 in
  • Phase: 1
  • Speed: 1550 rpm
  • Temperature Rating: 130 degF
The "Mighty-Mate" series of submersible pumps is designed for use in residential or light commercial dewatering applications and can be used to transfer groundwater or effluent. Cast iron models include a powder coated epoxy finish to prevent corrosion and are designed to provide great heat dissipation from the motor, ensuring a long service life. As with every Zoeller pump, each one is 100% pressure-tested, submerged and run to ensure quality and reliability for years of trouble-free performance! This attention to detail is an inherent feature of every pump in this series, making it one of the most reliable in the industry.

Effluent or Dewatering submersible Pump, Automatic, Series: Mighty-Mate M57, 43 gpm, 1-1/2 in Outlet, 19-1/4 ft Maximum Head, 3/10 hp, 115 VAC, 9.7 A, 60 Hz, 1550 rpm Motor, 3-Wire Cord, Non-Clogging Vortex Impeller, 130 deg F, Sleeve Bearing, Cast Iron, 10.0625 in H x 10.06 in W
  • Features
  • Float operated, 2-pole mechanical switch and variable level, long cycle systems available
  • Corrosion resistant, powder coated epoxy finish
  • No sheet metal parts to rust or corrode
  • Stainless steel screws, switch arm, guard and handle
  • No screens to clog, watertight, neoprene square ring between motor and pump housing
  • Solid, buoyant, polypropylene float, oil-filled, hermetically sealed, automatic reset thermal overload protected motor
  • Upper and lower sleeve bearings running in bath of oil, entire unit pressure tested after assembly, carbon and ceramic shaft seal
  • Watertight and dust tight, permanently oiled bearings
  • Stainless steel guard and handle, lower and upper bearings, oil-fed, cast iron, cast iron impeller, carbon and ceramic shaft seal
  • Entire unit pressure tested after assembly
  • Class B insulation, 7-1/4 in/3 in auto On/Off points
  • 1/2 in spherical solids handling, 9 ft cord, oil filled cooling
  • Cast iron cap, motor and pump housing, base, carbon and ceramic mechanical seals, engineered plastic impeller, stainless steel hardware, neoprene gasket
  • AISI 1215 cold roll steel motor shaft
  • Single phase, shaded pole, 3 wire cord and plug
  • 1-1/2 in NPT discharge