McDonald® 5426-005, 72190 90 deg Push-Fit Elbow, 1/2 in, CTS, Brass
AYM72190D
MFG #: 5426-005
- End Style: CTS
- Fitting / Connector Type: 90 deg Elbow
- Material: BRASS
- Nominal Size: 1/2 in
- Manufacturer: A.Y. McDonald
- Manufacturer #: 5426-005
- Method of Manufacture: Forged
- Pressure Rating: 200 psig
- Temperature Rating: 0 to 200 degF
McDonald® No-Lead Push-Fit Valves & Fittings are designed for use on copper tubing, PEX tubing and CPVC pipe. Push-Fit fittings eliminate the need for soldering, crimping or solvent welding and are designed for above ground indoor water applications. Push-Fit fittings comply with all applicable standards and are pressure rated at 200 psig from 0 to 200 deg F. McDonald® Push-Fit Valves & Fittings are a 21st century design for connecting fittings and valves to Copper, CPVC or PEX pipe. No soldering, crimping or solvent welding is necessary due to the special rubber O-ring and stainless steel gripper ring. The permanent connection is established in seconds and is capable of test pressures exceeding 500 psi. Push-Fit fittings are produced with low-lead forged brass and are ideal for use on plumbing, water and hydronic heating systems. The sleek disconnect clip allows the Push-Fit design to disassemble as fast as you can say Push-Fit! Unlike other competitors that use multi-step disassembly procedures, the advanced Push-Fit design offers a quick solution to typical installation errors.
McDonald® Push-Fit Elbow, Fitting/Connector Type: 90 deg Elbow, 1/2 in Nominal, CTS, 200 psig, 0 to 200 deg F, Brass, Forged
McDonald® Push-Fit Elbow, Fitting/Connector Type: 90 deg Elbow, 1/2 in Nominal, CTS, 200 psig, 0 to 200 deg F, Brass, Forged
- Features
- Fast installation requiring no special tools
- Secure, permanent connection with no soldering, crimping or solvent welding
- Wet repair of existing plumbing with no drying time required
- Allows easy transition from one tubing type to another
- 360 deg tubing rotation and easy pre-assembly installation
- Full port fittings for usage on domestic hot and cold water systems
- No soldering, no flux, no flame and no fire hazards
- The wetted surface of this product contacted by consumable water contains less than one quarter of one percent (0.25%) of lead by weight